Модуль аналогового вывода, 4 канала, 16 разрядов, выходной диапазон 0/4–20 мА
|
Наименование
|
SM 032, AO 4x16Bit, 0/4-20 mA |
|
Тип
|
032-1CD40 |
|
Габаритные размеры, В х Ш х Г, мм
|
12.9 mm x 109 mm x 76.5 mm |
|
Температура окружающей среды
|
0 °C ... 60 °C |
|
Количество выходов
|
4 |
|
Тип выходного сигнала
|
0…10V |
 |
|
Status indication
 |
RUN | MF | AO x | Description |
| green | red | red |
|
|
| ● | ○ | X | Bus communication is OK Module status is OK |
|
| ● | ● | X |
Bus communication is OK |
|
| ○ | ● | X |
Bus communication is not possible |
|
| ○ | ○ | X | Error at bus power supply | |
| X | B | X |
Error in configuration |
|
| ● | ○ | ● |
Error channel x
|
|
| on: ● | off: ○ | blinks with 2Hz: B | not relevant: X | ||||
Pin assignment
| PM - Power module | Pos. | Function |
Type |
Description | |
 |
1 | AO 0 | O | Channel 0 | |
| 2 | AGND | O |
Ground channels |
||
| 3 | AO 2 | O |
Channel 2 |
||
| 4 | AGND | O | Ground channels | ||
| 5 | AO 1 | O | Channel 1 | ||
| 6 | AGND | O |
Ground channels |
||
| 7 | AO 3 | O |
Channel 3 |
||
| 8 | AGND | O | Ground channels |
O: Output
Order no. |
032-1CD40 |
| Type | SM 032 |
| Module ID | 050C 25E0 |
General information |
|
| Note | - |
| Features | 4 outputs 16Bit Current 0(4)...20mA |
Current consumption/power loss |
|
| Current consumption from backplane bus | 65 mA |
| Power loss | 0.8 W |
Technical data analog outputs |
|
| Number of outputs | 4 |
| Cable length, shielded | 200 m |
| Rated load voltage | DC 24 V |
| Reverse polarity protection of rated load voltage |  |
| Current consumption from load voltage L+ (without load) | - |
| Voltage output short-circuit protection | - |
| Voltage outputs | - |
| Min. load resistance (voltage range) | - |
| Max. capacitive load (current range) | - |
| Max. inductive load (current range) | - |
| Output voltage ranges | - |
| Operational limit of voltage ranges | - |
| Basic error limit voltage ranges | - |
| Destruction limit against external applied voltage | - |
| Current outputs | |
| Max. in load resistance (current range) | 350 Ω |
| Max. inductive load (current range) | 10 mH |
| Typ. open circuit voltage current output | 12 V |
| Output current ranges | 0 mA ... +20 mA +4 mA ... +20 mA |
| Operational limit of current ranges | +/-0.2% |
| Basic error limit current ranges | +/-0.1% |
| Destruction limit against external applied voltage | max. 12V (30V for 1s) |
| Settling time for ohmic load | 0.25 ms |
| Settling time for capacitive load | - |
| Settling time for inductive load | 1.5 ms |
| Resolution in bit | 16 |
| Conversion time | 400 µs all channels |
| Substitute value can be applied | no |
| Output data size | 8 Byte |
Status information, alarms, diagnostics |
|
| Status display | yes |
| Interrupts | no |
| Process alarm | no |
| Diagnostic interrupt | no |
| Diagnostic functions | yes |
| Diagnostics information read-out | possible |
| Supply voltage display | green LED |
| Group error display | red LED |
| Channel error display | red LED per channel |
Isolation |
|
| Between channels | - |
| Between channels of groups to | - |
| Between channels and backplane bus | |
| Between channels and power supply | |
| Max. potential difference between circuits | - |
| Max. potential difference between inputs (Ucm) | - |
| Max. potential difference between Mana and Mintern (Uiso) | DC 75 V/ AC 50 V |
| Max. potential difference between inputs and Mana (Ucm) | - |
| Max. potential difference between inputs and Mintern (Uiso) | - |
| Max. potential difference between Mintern and outputs | - |
| Insulation tested with | DC 500 V |
Datasizes |
|
| Input bytes | 0 |
| Output bytes | 8 |
| Parameter bytes | 10 |
| Diagnostic bytes | 20 |
Housing |
|
| Material | PPE / PPE GF10 |
| Mounting | Profile rail 35 mm |
Mechanical data |
|
| Dimensions (WxHxD) | 12.9 mm x 109 mm x 76.5 mm |
| Weight | 60 g |
Environmental conditions |
|
| Operating temperature | 0 °C to 60 °C |
| Storage temperature | -25 °C to 70 °C |
Certifications |
|
| UL certification | in preparation |
| KC certification | yes |
| Order no. | Name/Description | |
|---|---|---|
|
031-1BB10 |
SM 031 - Analog input 2 inputs 12Bit Current 0(4)...20mA 2 wire |
 [Datasheet] [Manual] [STP] |
|
031-1BB30 |
SM 031 - Analog input 2 inputs 12Bit Voltage 0...10 V |
[Datasheet] [Manual] [STP] |
|
031-1BB40 |
SM 031 - Analog input 2 inputs 12Bit Current 0(4)...20 mA |
[Datasheet] [Manual] [STP] |
|
031-1BB60 |
SM 031 - Analog input 2 inputs 12Bit Current 0(4)...20mA 2 wire |
[Datasheet] [Manual] [STP] |
|
031-1BB70 |
SM 031 - Analog input 2 inputs 12Bit Voltage -10 V...+10 V |
[Datasheet] [Manual] [STP] |
|
031-1BB90 |
SM 031 - Analog input 2 inputs 16Bit Thermocouple type J, K, N, R, S, T, B, C, E, L Voltage -80mV...+80mV |
[Datasheet] [Manual] [STP] |
|
031-1BD30 |
SM 031 - Analog input 4 inputs 12Bit Voltage 0...10 V |
[Datasheet] [Manual] [STP] |
|
031-1BD40 |
SM 031 - Analog input 4 inputs 12Bit Current 0(4)...20 mA |
[Datasheet] [Manual] [STP] |
|
031-1BD70 |
SM 031 - Analog input 4 inputs 12Bit Voltage -10 V...+10 V |
[Datasheet] [Manual] [STP] |
|
031-1BD80 |
SM 031 - Analog input 4 inputs 16Bit 0 .. 3000 ohm resistance Resistance measurement with 2, 3, and 4-wires |
[Datasheet] [Manual] [STP] |
|
031-1BF60 |
SM 031 - Analog input 8 inputs 12Bit Current 0(4)...20mA 2 wire |
[Datasheet] [Manual] |
|
031-1BF74 |
SM 031 - Analog input 8 inputs 12Bit Voltage -10 V...+10 V |
[Datasheet] [Manual] |
|
031-1CA20 |
SM 031 - Analog input Direct connection of a resistor full bridge (DMS) or load cell 4- or 6-wire measurement 16 (24)Bit resolution Auto/self calibration zero point and final value Absolute exactness radical error ±0,1% (± 0,01%) Onboard power supply 2V5, 5V, 7V5, 10V and 12V |
[Datasheet] [Shortfacts] [Manual] |
|
031-1CB30 |
SM 031 - Analog input 2 inputs 16Bit Voltage 0...10 V |
[Datasheet] [Manual] [STP] |
|
031-1CB40 |
SM 031 - Analog input 2 inputs 16Bit Current 0(4)...20 mA |
[Datasheet] [Manual] [STP] |
|
031-1CB70 |
SM 031 - Analog input 2 inputs 16Bit Voltage -10 V...+10 V |
[Datasheet] [Manual] [STP] |
|
031-1CD30 |
SM 031 - Analog input 4 inputs 16Bit Voltage 0...10 V |
[Datasheet] [Manual] [STP] |
|
031-1CD35 |
SM 031 - Analog input 4 inputs 16Bit Voltage 0...10 V |
[Datasheet] [Manual] [STP] |
|
031-1CD40 |
SM 031 - Analog input 4 inputs 16Bit Current 0(4)...20 mA |
[Datasheet] [Manual] [STP] |
|
031-1CD45 |
SM 031 - Analog input 4 inputs 16Bit Current 0(4)...20 mA |
[Datasheet] [Manual] [STP] |
|
031-1CD70 |
SM 031 - Analog input 4 inputs 16Bit Voltage -10 V...+10 V |
[Datasheet] [Manual] [STP] |
|
031-1LB90 |
SM 031 - Analog input 2 inputs 16Bit Thermocouple Voltage -80mV...+80mV requires less parameter bytes than module 031-1BB90 |
[Datasheet] [Manual] [STP] |
|
031-1LD80 |
SM 031 - Analog input 4 inputs 16Bit 0 .. 3000 ohm resistance Resistance measurement with 2, 3, and 4-wires requires less parameter bytes than module 031-1BD80 |
[Datasheet] [Manual] [STP] |
|
032-1BB30 |
SM 032 - Analog output 2 outputs 12Bit Voltage 0...10 V |
[Datasheet] [Manual] [STP] |
|
032-1BB40 |
SM 032 - Analog output 2 outputs 12Bit Current 0(4)...20 mA |
[Datasheet] [Manual] [STP] |
|
032-1BB70 |
SM 032 - Analog output 2 outputs 12Bit Voltage -10 V...+10 V |
[Datasheet] [Manual] [STP] |
|
032-1BD30 |
SM 032 - Analog output 4 outputs 12Bit Voltage 0...10 V |
[Datasheet] [Manual] [STP] |
|
032-1BD40 |
SM 032 - Analog output 4 outputs 12Bit Current 0(4)...20mA |
[Datasheet] [Manual] [STP] |
|
032-1BD70 |
SM 032 - Analog output 4 outputs 12Bit Voltage -10 V...+10 V |
[Datasheet] [Manual] [STP] |
|
032-1CB30 |
SM 032 - Analog output 2 outputs 16Bit Voltage 0...10 V |
[Datasheet] [Manual] [STP] |
|
032-1CB40 |
SM 032 - Analog output 2 outputs 16Bit Current 0(4)...20 mA |
[Datasheet] [Manual] |
|
032-1CB70 |
SM 032 - Analog output 2 outputs 16Bit Voltage -10 V...+10 V |
[Datasheet] [Manual] [STP] |
|
032-1CD30 |
SM 032 - Analog output 4 outputs 16Bit Voltage 0...10 V |
[Datasheet] [Manual] [STP] |
|
032-1CD40 |
SM 032 - Analog output 4 outputs 16Bit Current 0(4)...20mA |
[Datasheet] [Manual] |
|
032-1CD70 |
SM 032 - Analog output 4 outputs 16Bit Voltage -10 V...+10 V |
[Datasheet] [Manual] [STP] |
Изделие: 032-1CD70
4 канала, 16 разрядов, выходной диапазон ±10 В
Изделие: 032-1BB30
2 канала, 12 разрядов, выходной диапазон 0…10 В
Изделие: 032-1BD40
4 канала, 12 разрядов, выходной диапазон 0/4–20 мА
Изделие: 032-1BD30
4 канала, 12 разрядов, выходной диапазон 0…10 В
г. Алматы, Ауэзовский район
ул. Толе Би 302, Литер "Д"
офис № 205
+7 (727) 268-0321
+7 (701) 082-9486
+7 (707) 493-7210
+7 (727) 268-0321
info@controllink.kz
